(1) The design of the circuit must be determined in detail after considering the possibility, feasibility and availability. No one wants to pull wires on the floor of a new home. At the same time, the circuit design should also pay attention to its flexibility, and sometimes it should not be too "consummate." Summarize a relatively simple principle: consider the next plug-in board in the position where the electrical plug is relatively concentrated, the effect is often better than the wall-mounted socket;
Millennium boat plate
(2) The bedroom ceiling light can be considered double control (bedside and entrance);
(3) According to the needs of living, the ceiling light of the living room can be installed with the switch (into the entrance hall and back to the main bedroom door);
(4) Observe whether there are modules in the telephone socket and the network cable socket;
(5) The surround sound line should be buried when the circuit is modified.
(6) Note that strong and weak wires cannot be in the same pipe and there will be interference;
(7) If the living room, kitchen, and bathroom are tiled, some locations may be properly considered without slotting;
(8) The socket is generally 30CM away from the ground, not less than 20CM, and the switch is generally 140CM away from the ground;
(9) The exhaust fan switch and telephone socket should be installed near the toilet instead of the wall of the bathroom door;
(10) The Yuba should be considered to be installed near the shower room or bath instead of the central position of the bathroom;
(11) Reservations for sockets may be considered for balconies, corridors, and cloakrooms;
(12) Spaces with mirrors and coat hooks should consider the lighting near the mirror;
(13) In the living room, master bedroom, and bathroom, the telephone line should be considered according to personal habits and convenience;
(14) A maximum of eight lines in a tube, and remember: each tube gap can not be less than 40%.
(15) How to charge the cassette must be stated in advance. This is the most hidden and darkest profit point for the transformation of the water circuit. A cassette market is also one or two dollars, while the decoration team often charges more than ten dollars, and the average home improvement needs a small number of cassettes to be five or sixty. Therefore, it is normal for students to throw a few hundred dollars for this. Death is resisting pulling it out today. It has only one purpose. We remember five words: cut it down!
(16) The position of the socket is very important, and often the socket is just behind the bedside cabinet, causing the cabinet to not be against the wall. It is generally not wrong to let the outlet be as close as possible, but if you leave the location of the outlet improperly, it may conflict with the placement of the furniture or the installation of the electrical appliance in the later period. Students must remember;
(17) The sockets of some kitchens are also convenient with switches, so as to avoid the inconvenience of pulling and unplugging the rice cooker plugs from time to time, for example.
(18) There is no need to set too many sockets behind the TV. It is better to put a socket board on the side of the TV afterwards.
(19) In electrical codes, buried pipe must be PVC pipes and heads must be changed.
(20) Circuit modification It is necessary to increase the line capacity according to the use of household appliances.
(21) Clear communication intentions and design ideas with workers. And on the wall bullets painted actual circuit transformation route.
>>> Qi family classroom: for you to buy three ways to buy home hardware
Home Decoration Design Considerations Living Room Outlet Switch Appliances Living Room TV TV Decoration Bedroom Door Decoration Living Room Master Bedroom Decorating Cabinet Door Cabinet Kitchen Cabinet Door Bathroom Design Bathroom Door Decoration Home Decoration Home Bedroom Lamp
Walk Through Metal Detector CO.,LTD , http://www.nsmetaldetector.com