| Home>Bearing knowledge> SKF imported bearing data should have the function |
SKF imported bearing data should have the function
Source: China Bearing Network Time: 2014-02-04
| /*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089'; |
.1) The difficulty of forming alloys by metallurgical materials.
.2) Affinity of materials and smoothing agents.
.3) The conflict factor of the pair of data in the absence of smoothness.
.4) Microscopic arrangement of data.
.5) Thermal conductivity of the data.
.6) The size of the data surface and the characteristics of the oxide film.
2. The embedded data allows the external hard particles to be clamped in the smoothing agent to avoid scratching or (and) wear of the abrasive particles. For metal data; low hardness and low modulus of elasticity; embeddedness is good; not metal The data is not fixed; for example, carbon graphite; low modulus of elasticity; but the embedding is not good. Sliding SKF bearings generally use softer data and harder data to form a conflict; generally use softer materials as bearing pads.
3. The running-in property is in the running-in process of the shaft diameter and the bearing bush; the shaft diameter and the bearing bushing error, the coaxiality error, and the appearance roughness parameter value are reduced; the touch is uniform; then the ability of the conflicting force and the wear rate is lowered.
4. The conflict compliance data relies on the elastoplastic deformation of the surface layer to compensate for the initial cooperation failure and the deflection function of the axis of the sliding conflict. The data with low elastic modulus is better.
5. Wear resistance is the ability of the auxiliary data to resist wear. Under regular wear conditions; wear rate or wear degree, the reciprocal of wear amount to indicate wear resistance.
6. Resistance to fatigue Under the cyclic load, the data can resist the fatigue and damage. At the operating temperature; the strength, hardness, impact strength and arrangement uniformity of the bearing material are very important for the fatigue and wearability. Generally, the resistance to fatigue is poor.
7. Corrosion resistance data resists the ability of corrosion. Smooth oil will gradually oxidize when used in the atmosphere; acid substances will occur; and extreme pressure additives are also contained in most smooth oils; they will corrode SKF bearings; therefore; SKF bearings The data requirements are corrosion resistant.
8. The state in which the cavitation resistant solid moves relative to the liquid; when the bubble in the liquid breaks near the solid appearance; the partial impact high pressure or part of the high temperature occurs; the cavitation wear will be incurred. The data against the cavitation wear is called gas resistance. Corrosion. General; copper-lead alloy, tin-based SKF imported bearing alloy and aluminum-zinc-silicon alloy have good cavitation resistance.
9. Compressive strength accepts unidirectional loads without being crushed or the scale does not change.
Recommend to friends comments close window
| Bearing related knowledge |
| The problems that should be considered when the roll bearing combination is drawn are detailed. What are the common quality defects of the bearing NA4906 used after heat treatment? How to install high-speed bearings for bearing grinding? |
This article links to http://
Please indicate the bearing network http://
Previous: Bearing parts Next: Differences between ball bearings and roller bearings
Chunlei Quntification Co.,Ltd , https://www.hychunleitools.com